Interface Range Command. Interface Range Command in Cisco Packet Tracer CCNA Networking Interface Range Command Introduction : Cisco has been working for long to streamline and minimize the configuration overhead on networking devices The interface range command is particularly useful because switches have many interfaces and the same settings are often applied to multiple interfaces.
Cisco Tip; Working With Port Ranges YouTube from www.youtube.com
In the interface configuration mode with the range keyword, all entered commands are applied to all interfaces within the range until you exit the interface configuration mode. Syntax Switch (config)#interface range Options
Cisco Tip; Working With Port Ranges YouTube
Command Interface Range Use This is the modern way to configure VLANs The Interface Range Specification feature is implemented with the interface range command, which causes the device to enter interface range configuration mode The cisco interface range command runs on all platforms that support Cisco IOS Release 12.0 (7)XE, Release 12.1 E, and Release 12.1 (5)T
Configuring LAG Settings on a Switch through the Command Line Interface. The interface range command is particularly useful because switches have many interfaces and the same settings are often applied to multiple interfaces. Interface Range Command Introduction : Cisco has been working for long to streamline and minimize the configuration overhead on networking devices
Configuring LAG Settings on a Switch through the Command Line Interface. interface range command The interface range command allows you to configure multiple interfaces at once if i want to select all of them for common configurations, how do i select them? My cisco book shows interface range fastethernet 1/0-48 The question is why the book is considering the first port as 0? if i have to select ports from fa0/1-24, how can i use the "interface range" to select this range? thanks a lot!